Poly-Craftsman Column Specifications

Product Information Limited Lifetime Warranty (warranty coverage requires adherence to Turncraft's installation and painting instructions, and is limited to materials only.) Fluted and Raised Panel shafts are designed to allow field trimming up to 6" (trim from bottom only). Columns must be trimmed to 1/4" shorter than the required opening to allow for product expansion. (The cap moulding will cover the 1/4" space.) Specifications shown are subject to change without notice. Columns are NOT load bearing. Non-Tapered shafts are 1/2" shorter than nominal. The cap can be raised to the overhead beam/soffit to cover any gaps.

TAPERED COLUMNS:

Column Nominal Bottom Width	Column NET Bottom Width*	Column Nominal Top Width	Column NET Top Width	Base Plinth Width	Base Plinth Height	Base Moulding Height	Base Inside Opening	Cap Abacus Width	Cap Abacus Height	Cap Moulding Height	Cap Inside Opening
12"	11-5/8"	8"	7-5/8"	15-5/8"	1"	1-1/4"	7-5/8"	11-5/8"	1"	1-1/8"	3-5/8"
16"	15-5/8"	12"	11-5/8"	19-5/8"	1"	1-1/4"	11-5/8"	15-5/8"	1"	1-1/8"	7-5/8"
20"	19-5/8"	14"	13-5/8"	23-5/8"	1"	1-1/4"	13-5/8"	17-5/8"	1"	1-1/8"	9-5/8"
24"	23-5/8"	16"	15-5/8"	27-5/8"	1"	1-1/4"	15-5/8"	19-5/8"	1"	1-1/8"	11-5/8"
* before trimming

NON-TAPERED COLUMNS:

Column Nominal Width	Column NET Width*	Inside Diameter	Base Height	Cap Height	Cap and Base Width	Number of Flutes	Flute Width (approx)	Side of Shaft Before Flute	Recess Width on Raised Panels*	Side & Top of Shaft Before Recess*
6	5-5/8"	4-3/8"	9-1/4"	7-1/4"	6-7/8"	5	1/2"	1-1/16"	1-1/4"	1-1/2"
8	7-5/8"	6-3/8"	9-1/4"	7-1/4"	8-7/8"	5	3/4"	1-3/16"	1-1/4"	1-1/2"
10	9-5/8"	8-3/8"	9-1/4"	7-1/4"	10-7/8"	5	1"	1-5/16"	1-1/4"	1-1/2"
12	11-5/8"	10-3/8"	9-1/4"	7-1/4"	12-7/8"	5	1-1/4"	1-3/16"	1-1/4"	1-1/2"
* also applies to TAPERED raised panel columns